Rhino-Rack RBLW, Fitting Instruction

Page: 11 / 28

Page 11 of 28
Remove burrs and clean the cut end of the
power roller, slide the rubber rings onto the
roller in any position. Place the rings in hot
water, this will aid the rings to slide onto the
roller.
Remove the Z bracket, insert the drilled end of
the power roller onto the winch power roller
shaft, insert the Z bracket power roller bush into
the roller, insert the Z bracket onto the
longitudinal bar, adjust the roller to be parallel to
the rear crossbar. Tighten the bolts as previous
described and check that the channel nuts are
fully located across the bar.
Align the holes in the roller with the winch shaft, knock in the power roller drive pin until it is flush with
the roller.
Align holes and
knock in p ins.
Pins to be flush
with roller.
Clean cut end .