Page 16 of 28
Fitting the front roller to the longitudinal bars.
Z brackets.
Note: - The bushes for the front roller have a smaller spigot diameter.
Assemble the spindle bolt, bush and bush nut, the bush nut must be positioned to allow the bush to have
minimal end float and rotate freely. Assemble the bush and spindle onto the Z bracket, fit the flat washer,
screw on the Nyloc nut and tighten. Assemble the M10 x 20mm bolts, shake proof washers and channel
nuts as per the diagram, ensure that the channel nuts are loose.
Smaller spigot diameter
Slide the Z brackets into the longitudinal bars with the roller bush facing inwards. Position one of the Z
brackets at X – 200mm from the power roller. (X = the distance from the bow to the Balance point).
Tighten the attachment bolts;
check that the channel nuts are fully located across the bar.
Position the other Z bracket in line with previously attached Z bracket and finger tighten the attachment
bolts.
front roller bushes only.
Front roller
Power roller
Distance = X
–
200
mm
Summary of Contents for RBLW
Page 1: ...Page 1 of 28 THE BOAT LOADER FITTING INSTRUCTION CONTROLLED...
Page 10: ...Page 10 of 28...
Page 24: ...Page 24 of 28...
