Rhino-Rack RBLW, Fitting Instruction

Page: 15 / 28

Page 15 of 28
Marking and Cutting the roller.
Align one end of the roller with the inside edge of the roller bush flange. Mark the other end of the roller
adjacent to the inside edge of the driver side roller bush flange as per the diagrams.
Remove burrs and clean the cut end of the roller. Remove the pivot roller bracket from the driver side
longitudinal bar, insert the pivot roller into the winch side bush, insert the driver side bracket bush into
the roller. Insert the pivot roller bracket into the longitudinal bar, adjust the pivot roller to be parallel to
the power roller.
Tighten the attachment bolts as previously described and check that the channel nuts are fully located
across the bar.
The pivot roller must rotate freely.
Align roller end to
roller bush flange.
Mark roller at the roller
bush flange for cutting.
Must be parallel
and rotate freely.