107
1.800.627.4499
DN-Series Integrated Programmable Controls
DOAS
BMS ACCESS
13.3.2 BACnet IP Settings
First, set the IP address of the controller in the same
General Settings
area.
u
Set DHCP to Off if static.
u
If Static, set the IP, mask, and gateway if required.
u
Set Update?
To Yes (power will need to be cycled. This can be done after all of the
other settings.)
Next, set the BACnet Device ID. This screen allows you to set the ID digit by digit.
Last, set the BACnet port if different from the 47808 (BAC0). This screen allows you to set the
BACnet Device ID scrolling up or down.
If you need to set the timing values, you can do that here.
13.3.3 BACnet MSTP Settings
First, set the BACnet Device ID. This screen allows you to set the ID digit by digit.
NOTE: Whenever
the BMS type is
changed, power to
the controller must
be cycled.
