63
│
7.9.17. Dehumidifier
Dehumidifier settings are described in Chap. 5.24.
7.9.18. Parallel operation
The function switches parallel to the set signal output – both the outputs switch in parallel.
The function can be inverted, so the output switches contrary to the set signal output.
7.9.18.2. Parallel to
Here, the output can be selected, which this function should be activated parallel to. Every
available signal output can be selected.
7.9.18.3. Delay
In this menu, it is set how long to wait after switching the signal output until the parallel
operated relay switches as well.
7.9.18.4. Followup time
In this menu, it is set how long the parallel-operated relay continues to operate after the set
signal output has been deactivated.
7.9.20. Always on
The output is permanently switched on.
7.10. Signal V1 (settings for V1 output – heating circuit pump)
In the RegulusBIO load unit the boiler pump is connected to the V1 output. Do not change
this setting.
7.11. Signal V2 (settings for V2 output – boiler circulation pump)
In the RegulusBIO load unit the boiler pump is connected to the V2 output. Do not change
this setting.
7.12. Commissioning
The commissioning help guides you through the necessary basic settings in the correct order,
and provides brief descriptions of each parameter in the display. Pressing the “esc” key takes
you back to the previous value so you can look at the selected setting again or adjust it if
desired. Pressing the “esc“ more than once takes you back step by step to the selection
mode, thus cancelling the commissioning help (see also E.2.).
May be launched by an expert during commissioning only! Observe the explanations
for the individual parameters and check whether further settings are necessary for
your application.
7.13. Factory Settings
All settings can be reset, returning the controller to its delivery state.
The entire parametrization, statistics, etc. of the controller will be lost irrevocably. The
controller must then be commissioned once again.
7.14. Eco Display Mode
In Eco Display Mode the backlight of the display is switched off if no buttons are pushed for
2 minutes. If a message exists, the backlight does not switch off.
If a message exists, the backlight does not switch off until the message has been
read by the user.
