│
30
E.2. SETUP WIZARD
The setup wizard guides you through the necessary basic settings in the correct order, and
provides brief descriptions of each parameter in the display. Pressing the “esc” key takes you
back to the previous level so you can look at the selected setting again or adjust it if desired.
Pressing the “esc“ more than once takes you back step by step to the selection mode, thus
cancelling the commissioning help.
The setup wizard can be repeatedly accessed in menu 7. Special functions ►7.12.
Commissioning at any time.
HOW TO PROCEED
1. The controller offers hydraulic variants:
1.Combi+HC+SFB
or
2.ThSt+HC+SFB+heat transf.
Select the appropriate variant for your
system and press the
Info
button.
2. The selected hydraulic variant 1 or 2
appears on the display; confirm it by
pressing the
OK
key. After confirming,
please
wait
for the controller to load the
settings (this may take several seconds).
3. Leave the Operating mode as “
Heating
”,
confirm by pressing
OK
button.
4. S/W transition is recommended to be left at
the values of
18 °C
(for Day mode) and
12 °C
(for Night mode). Confirm by
pressing
OK
button.
5. Heating curve
You can choose between a “simple” and a “split” heating curve.
If you wish to set a “simple” heating curve
, proceed to menu 5.1.5. Heating curve. A
simple heating curve is sufficient supposed a room temperature sensor or a Caleon room
unit is installed.
If you wish to set a “split” heating curve
, proceed as described in the chapter
SETTING A SPLIT HEATING CURVE. A split heating curve is recommended in case
when no room temperature sensor / no Caleon room unit are installed.