iv
N-Tron
®
Series 700/7000 Managed Industrial Ethernet Switch Hardware Manual - Volume I
Revised 2019-08-22
Preface
Drawing No. LP0988
Preface
Disclaimer
Portions of this document are intended solely as an outline of methodologies to be followed during the installation
maintenance and operation of
N-Tron
®
Series 700 and 7000 models switches. It is not intended as a step-by-step
guide or a complete set of all procedures necessary and sufficient to complete all operations.
While every effort has been made to ensure that this document is complete and accurate at the time of release, the
information that it contains is subject to change. Red Lion Controls is not responsible for any additions to or
alterations of the original document. Industrial networks vary widely in their configurations, topologies, and traffic
conditions. This document is intended as a general guide only. It has not been tested for all possible applications,
and it may not be complete or accurate for some situations.
Users of this document are urged to heed warnings and cautions summarized at the front of the document, such as
electrical hazard warnings.
Compliance
Information
It is recommended that the owner of this equipment determine and ensure conformance with any specific and
applicable local regulations.
Part
15
of
the
Federal
Communications
Commission
(FCC)
‐
A
Rules:
Interference
Every effort has been made to ensure that this equipment is designed to comply with the limits for a Class A digital
device, as described in the FCC Rules.
This product complies with Part 15 of the FCC-A Rules.
Operation is subject to the following conditions:
1.
This device may not cause harmful Interference
2.
This device must accept any interference received, including interference that may cause undesired operation.
Note
- This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. Operation of this device in
a residential area is likely to cause harmful interference in which case the user will be required to
correct the interference at their own expense.
Déclaration
de
conformité
FCC
Ce produit est conforme à la partie 15 des règles de la FCC -A
Utilisation est soumise aux conditions suivantes:
1.
Ce dispositif ne doit pas causer des interférences nuisibles
2.
Cet appareil doit accepter toute interférence reçue, y compris les interférences qui peuvent causer un mauvais
fonctionnement.
