N-Tron
®
Series 700/7000 Managed Industrial Ethernet Switch Hardware Manual - Volume II
2-57
Hardware Installation
Revised 2019-08-22
Mounting the Switch
Drawing No. LP0988
1.
For the 709FX, 710FX2, 711FX3, 712FX4, 714FX6, 7010TX, and 7012FX2, models ensure the CPMA
mounting bracket was factory installed on the switch.
2.
While supporting the unit, align the mounting brackets slots with the desired installation location on the flat
surface.
3.
Mark the mounting brackets slot locations.
4.
Drill a hole at each marked location
5.
While supporting the unit, align the mounting brackets slots with the drilled mounting holes.
6.
Insert a mounting screw through the right or left mounting bracket and hand tighten. Repeat on the other side.
7.
Finish tightening the first two mounting screws and install the remaining two mounting screws securing the
unit.
8.
Connect any communications cables to the switch.
9.
Install the power and ground wires.
10.
Apply power to the power supply.
2.3.5
Rack
and
Panel
Mounting
Instructions
for
7026TX
Model
The 7026TX model is preconfigured with standard rack mount brackets used to mount the unit to standard 19"
racks. As an alternative we offer the 7026TX Panel Mount Assembly (P/N: 7026TX-PMK) used to securely mount
the unit to a panel or other flat surface.
A clearance of 1 inch should be observed on the sides, back, top and bottom to allow proper ventilation. Also, a
cable bend radius of 2 inches should be observed for the front and back side of the unit.
2.3.5.1 Rack
Mounting
7026TX
Model
Install the switch in a standard 19” rack using the mounting holes as shown in the diagram above.
1.
While supporting the unit, align the mounting brackets slots with the rack mounting holes.
2.
Insert a mounting screw into the rack mounting hole through the right or left mounting bracket and hand
tighten. Repeat on the other side.
3.
Finish tightening the first two mounting screws and install the remaining two mounting screws securing the
unit to the rack.
4.
Connect any communications cables to the switch.
5.
Install the power and ground wires.
6.
Apply power to the power supply.
