Revised 2019-08-22
Hardware Installation
Drawing No. LP0988
Mounting the Switch
2-54
N-Tron
®
Series 700/7000 Managed Industrial Ethernet Switch Hardware Manual - Volume II
2.
Then, gently rotate the front of the switch downward, towards the panel.
3.
Push the bottom of the switch towards the rail until it locks into place.
4.
Apply upward force to verify the switch is securely installed.
5.
Connect any communications cables to the switch.
6.
Install the power and ground wires.
7.
Apply power to the power supply.
2.3.2
DIN
‐
Rail
Removal
Instructions
709FX,
710FX2,
711FX3,
712FX4,
714FX6,
7010TX,
7012FX2,
and
7506GX2
Models
Remove the switch from standard 35mm DIN-Rail as shown in the diagram above.
1.
Ensure power from the power source is off.
2.
Disconnect power and ground wires.
3.
Disconnect any communications cables from the unit.
4.
Pull forward on the bottom of the unit until it disengages from the bottom of the DIN-Rail.
5.
Carefully lift the switch upward and away from the DIN-Rail and panel.
