Revised 2019-08-22
Hardware Installation
Drawing No. LP0988
Mounting the Unit
2-40
N-Tron
®
Series 700/7000 Managed Industrial Ethernet Switch Hardware Manual - Volume I
2.3.3
DIN
‐
Rail
Removal
Instructions
From
Vertical
Mounting
Remove the switch from standard 35mm DIN-Rail as shown in the diagram above.
1.
Ensure power from the power source is off.
2.
Disconnect power and ground wires.
3.
Disconnect any communications cables from the unit.
4.
Insert a standard flat/slotted screwdriver into the slot provided on the DIN-Rail clip.
5.
Using the base of the switch as a pivot point, apply upward force on the screwdriver to release the DIN-Rail
clip.
6.
With the DIN-Rail clip latching mechanism released, continue to rotate the switch upward and away from the
panel.
7.
Once the switch has been rotated upward, remove the screwdriver.
Carefully lift the switch upward and away from the DIN-Rail and panel.
2.3.4
Bulkhead
Mounting
708M12
and
716M12
Models
The 708M12 and 716M12 models are designed for bulkhead mounting or within an enclosure and are IP67 rated.
There are optional Din-Rail mounting kits with metal or plastic clips available. This section includes the mechanical
dimensions and drill hole placements to consider when bulkhead mounting the unit. Allow at least 3” of horizontal
clearance in the installation location for copper cable bend radius.
