Raven viper, Installation & Operator'S Manual

Page: 92 / 182

C
HAPTER
8
84 Viper/Viper 4+ Installation & Operation Manual
EQUIPMENT SETUP - MEASUREMENTS TAB
1. Touch the Edit icon in the Machine Panel to view the machine devices.
2. Touch the profile buttons for the machine or implements currently assigned to the machine configuration to
view the General Information tab for the selected machine or implement.
NOTE: Use the page navigation at the bottom of the prompt, or swipe across the screen, to access other
information for profiles assigned to the selected machine configuration.
3. Select the Equipment tab to view the currently configured section group information. Refer to View Section
Groups section on page 72 for information on the section group display or the Section Settings section on
page 73 for assistance with creating a new section group.
4. Select the Edit button in the desired section group to edit section group information.
5. Touch the Measurements tab to access the following settings for the selected section group:
EQUIPMENT OFFSETS
Use the following settings to configure the location of the section group on the machine or implement:
Left/Right Offset Direction. Touch the left/right offset direction drop down and select the overall offset
for the selected section group from the center-line of the machine or implement.
Left/Right Offset Distance. Select the offset distance field and enter the distance from the center-line of
the machine or implement to the center of the section group in inches [centimeters]. The left/right offset
distance must be measured perpendicular to the direction of travel.
Fore/Aft Offset Direction. Touch the fore/aft offset direction drop down and select the position of the
section group from the machine or implement pivot point.
NOTE: The fore equipment offset may not be available when configuring some implement types.
Fore/Aft Offset Distance. Select the offset distance field and enter the distance from the pivot point to the
section group in inches [centimeters]. The fore/aft offset distance must be measured parallel with the direction
of travel.
EQUIPMENT SETUP - SECTIONS TAB
1. Touch the Edit icon in the Machine Panel to view the machine devices.
2. Touch the profile buttons for the machine or implements currently assigned to the machine configuration to
view the general information tab for the selected machine or implement.
NOTE: Use the page navigation at the bottom of the prompt, or swipe across the screen, to access other
information for profiles assigned to the selected machine configuration.
Edit
or
Self-Propelled
Machine Profile
Pull-Type
Implement Profile
Equipment Tab Edit Measurements
Tab
Edit
or
Self-Propelled
Machine Profile
Pull-Type
Implement Profile
Equipment Tab Edit Sections Tab