Rauch AXENT Series, Operator'S Manual

Page: 131 / 170

General maintenance and servicing
125
9
9.3 Cleaning
Spreading material and dirt increase corrosion.
To preserve the value of your machine, clean it
with a soft water jet immediately
each time after using it.
Observe especially the following instructions when cleaning:

Only clean oiled machines at washing points equipped with an oil separator.

When cleaning with high pressure, never aim the jet directly at warning signs,
electrical equipment or hydraulic components.
9.3.1 Cleaning the bearings of the guide rollers
Dust and dirt accumulate at the guide rollers of the conveyor belt during
spreading operation.

Clean the guide rollers. You must open the side covers to do so.
The procedure below describes how to open a side cover. Follow the same
procedure for all side covers. The guide rollers are covered by three side covers
on each side of the machine.
1. Insert an adjustment lever
through the side cover into
the sheet guide.
2. Raise the adjustment lever.

The lock is released.

The side cover is
unlocked.
Figure 9.2: Using the adjustment lever
3. Open and remove the side
cover.
Figure 9.3: Opening the side cover
b
a