Rauch AXENT Series, Operator'S Manual

Page: 125 / 170

General maintenance and servicing
119
9
9 General maintenance and servicing
9.1 Safety
Additional hazards that do not occur during operation of the machine are present
during maintenance and servicing work.
Any maintenance and service work is to be conducted with increased alertness
at all times. Work particularly thoroughly and cautiously.
Observe the following instructions in particular:

Welding and work on the electrical and hydraulic systems is to be carried out
by qualified technicians only.

Spare parts must at least comply with the technical requirements specified by
the manufacturer. This is ensured, for example, only by genuine spare parts.

Only qualified personnel are allowed to repair tyres and wheels with suitable
assembly tools.

Before starting any cleaning, maintenance, or servicing work, and when
correcting faults, switch off the tractor engine and wait until all moving parts
of the machine come to a stop.

Only an instructed and authorised specialist workshop is permitted to perform
repair work.

The hydraulic circuit contains two nitrogen tanks. They are under residual
pressure even after the system has been shut down. Slowly and carefully
open the screw connections of the hydraulic circuit.
NOTICE
Observe the warning notices in chapter 3: Safety, page 5 .
Take particular note of the instructions in section 3.8: Maintenance and
servicing, page 12 .