OPERATION
G2X Status LED’s
The top of the G2X contains four LED’s that provide information concerning the status of the system.
PWR LED
•
The PWR LED will glow a solid
RED
, when power is applied to the system.
•
The PWR LED will flash slowly (1/sec) while data is being recorded. (vehicle speed over 25
MPH)
•
The PWR LED will flash quickly (10/sec) if the power supply drops below 9 volts. Any open
data files will be closed and data will not record begin recording again until the low power
condition is corrected.
CARD LED
1.
The CARD LED will flash
YELLOW
anytime data is writing to the compact flash memory
card.
2.
If the memory card is removed while data is recording (.i.e. the red PWR LED is flashing
slowly) the CFC LED will turn on solid and all data for that recording will be lost.
3.
The power to the G2X should always be off before inserting or removing the compact flash
memory card. You may turn the G2X power off in the middle of a recording, however, doing so
will result in lose of the last 5 seconds of data.
!!! IMPORTANT WARNING !!!
ALWAYS insure the power to the G2X is OFF, when inserting or removing the Compact Flash card.
25
