Racal Instruments 3162A/B, User Manual

Page: 29 / 144

User Manual 3162A/B
Configuring The Instrument 2-1
Chapter 2
CONFIGURING The INSTRUMENT
Installation
Overview
This chapter contains information and instructions necessary to prepare the
Model 3162A/B for operation. Details are provided for initial inspection,
grounding safety requirements, repackaging instructions for storage or
shipment, logical address selection and installation information.
Unpacking and
Initial Inspection
Unpacking and handling of the generator requires normal precautions and
procedures applicable to the handling of sensitive electronic equipment. The
contents of all shipping containers should be checked for included accessories
and certified against the packing slip to determine that the shipment is
complete.
Safety
Precautions
The following safety precautions should be observed before using this product
and associated computer. Although some instruments and accessories would
normally be used with non-hazardous voltages, there are situations where
hazardous conditions may be present.
This product is intended for use by qualified persons who recognize shock
hazards and are familiar with the safety precautions required to avoid possible
injury. Read the operating information carefully before using the product.
Exercise extreme caution when a shock hazard is present. Lethal voltage may
be present on cables, connector jacks, or test fixtures. The American National
Standard Institute (ANSI) states that a shock hazard exists when voltage levels
greater than 30V RMS, 42.4V peak or 60 VDC are present.
WARNING
For maximum safety, do not touch the product, test cables,
or any other instrument parts while power is applied to the
circuit under test. ALWAYS remove power from the entire