© Copyright Qvis ®. All documentation rights reserved.
28
Figure 3-18
3.6 Detect
3.6.1 Go to Detect Menu
In the main menu, from Setting to Detect, you can see motion detect interface. See
H
Figure 4-
20.There is three detection types: motion detection, video loss, camera masking.
The video loss has no detection region and sensitivity setup. Also camera masking has no
detection region setup.
You can see motion detect icon if current channel has enabled motion detect alarm.
You can drag you mouse to set motion detect region without using the Fn button. Please
click OK button to save current region setup. Right click mouse to exit current interface.
3.6.2 Motion Detect
Detection menu is shown as below. See Figure 4-21.
Event type:
from the dropdown list you can select motion detection type.
Channel:
select the channel to activate recording function once alarm occurred. Please make
sure you have set MD record in encode interface(Main Menu->Setting->Schedule) and schedule
record in manual record interface(Main Menu->Advanced->Manual Record).
Enable
: Check the box here to enable motion detect function.
Latch:
when motion detection complete, system auto delays detecting for a specified time. The
value ranges from 10-300(Unit: second)
Region:
Click select button, the interface is shown as in Figure 4-22. Here you can set motion
detection zone. There are 396(PAL)/330(NTSC) small zones. The green zone is current cursor
position. Grey zone is the motion detection zone. Black zone is the disarmed zone. You can
click Fn button to switch between the arm mode and disarm mode. In arm mode, you can click
the direction buttons to move the green rectangle to set the motion detection zone. After you
completed the setup, please click ENTER button to exit current setup. Do remember click save
button to save current setup. If you click ESC button to exit the region setup interface system
will not save your zone setup.
Please input the
corresponding information
here, if you just upload the
image FTP.
