Introduction
QMS 4060 Print System Getting Started
2-2
Introduction
This chapter explains how to set up your QMS 4060 Print System for
the first time.
It includes information on finding a good location for the printer,
unpacking and checking the shipment contents, installing toner and
developer, loading the trays, turning the printer on, and printing a
start-up page.
Finding a Good Location
Your QMS 4060 Print System operates in any computing environment
with the following requirements.
The Printer Must Be Placed...
n
Away from cooling and heating sources, extreme temperature
changes, direct sunlight, excessive dust, corrosive chemicals or
vapors, water pipes, refrigerators, any strong electromagnetic
field (such as that created by an air conditioner), and excessive
vibration. Don’t connect it to the same electrical outlet as noise-
generating equipment.
n
In an area with a temperature range of 59° - 95° F/15° - 35°C and
relative humidity range of 40% -60% (optimal).
n
On a hard, level surface capable of supporting the 298lb (135 kg.)
printer.
n
Close to an easily accessible power supply.
n
In a well-ventilated room.
»
Note:
The clearances shown below allow for easy servicing and
maintenance. Under normal operation the rear clearance is required
only to be greater than 6 inches/ 15.25 cm.
