Printronix PrintNet P8000 Line, User Manual

Page: 179 / 240

Store Commands
179
store pserver opts [[-]jobsecurity]
[jobtimeout <SECONDS>] [jobcontrol[off|standard|
enhanced|fast]] [[-]multcp]
Example:
store pserver opts -jobsecurity
jobcontrol
is not used in this product.
Example:
store pserver opts jobcontrol [fast]
jobcontrol
is used to have different levels of secure printing.
This is available as a performance enhancement for LPR, TCP
socket printing etc. When jobcontrol is set to enhanced all jobs
will be supported with job flow control.
NOTE: When jobcontrol is disabled, dynamic config loading on a
model change is also disabled.
•
off . no job control; no SOJ/EOJ commands. The printer prints
faster in off mode.
•
standard . (the default) traditional job control with immediate
acknowledgements of SOJ/EOJ commands.
•
enhanced . job control with EOJ acknowledgements held off by
the printer until job is fully printed. The printer prints slower in
enhanced mode.
•
fast . The EOJ (End of Job) packet is acknowledged
immediately. Use this selection if the job is timed out due to a
delay in the acknowledgement of the EOJ packet because of
the amount of data printing.
To monitor the printer, use the telnet command “lpstat.” The normal
status reported on the first line of the lpstat response is the status of
the queue (LPQ) within the PrintNet. The status reported does not
reflect the state of the print job once it has been sent from the
PrintNet to the printer.
The new line at the bottom of the lpstate response labeled “printer
job:” can report one of two status values:
a. In Progress . A job in the printer is not yet finished.
b. Done . There are no jobs in the printer. All previous jobs are
finished.