Printronix PrintNet P8000 Line, User Manual

Page: 128 / 240

Chapter 8
Configuring on AS/400 as an IPDS Printer
128
NOTE: The lines in bold in Figure 33 are not used by PSF/400.
Instead, PSF/400 uses the information entered in the
device description screen.
3. The following parameters are recommended:
a. PSF configuration (PSFCFG)
The name used for this PSF configuration object. The
name must match the user-defined object name
(
USRDFNOBJ
) in the printer DEVD.
b. IPDS pass through (IPDSPASTHR)
To print SCS files, specify
*YES
, PSF/400 transforms SCS
into IPDS before printing.
c. Activate release timer (ACTRLSTMR)
Specifies the point at which the release timer (
RLSTMR
) is
activated. Set to
*NORDYF
.
d. Release timer (RLSTMR)
Specifies the amount of time to wait before a session or
dialog is released without terminating the writer. The
ACTRLSTMR
parameter specifies when this timer is to be
activated. Set the parameter to a value at least equal to the
TIMEOUT value on the printer. The recommended value is
*SEC15
.
Configuring PSF with CRTDEVPRT on V3R7 and
Above
This section describes how to create a printer device description.
1. At the AS/400 command line, enter a command in the form:
CRTDEVPRT DEVD( printer_type ) DEVCLS(*LAN) TYPE(*IPDS)
MODEL(0) LANATTACH(*IP) AFP(*YES) PORT(5001)
FONT(11) FORMFEED(*CONT)
RMTLOCNAME(‘128.9.12.134’)
USRDFNOBJ(AFP/5000NETPRT *PSFCFG)
TEXT(‘ printer_type NETWORK PRINTER’)
Where
printer_type
(e.g., T5000, P7000) is the model of
your printer.