Primera Impressa 2, User Manual

Page: 81 / 104

76 Section 8: Maintenance
Digital Label and Decal Press 2 UserÕs Manual
4. The Print Pressure Bracket is held in place by two Securing Levers and is
connected to the printer electronically by its Sensor Connector. Each of these
items is marked with a yellow colored end. To remove the bracket, first
turn
the printer power OFF , then disconnect the Sensor Connector by sliding it
toward the left-hand side of the printer until it stops.
5. Next, firmly pull up on each Securing Lever until each is in its fully opened
position as shown above. Some force is required to unlatch these Securing
Levers. Note that lifting both the left and right Securing Levers simultaneously
may reduce the effort required to unlatch the levers.
Print Pressure
Bracket
Securing
Lever
Sensor Connector
DLDP2.qxd 3/29/99 9:56 AM Page 76