Primera Impressa 2, User Manual

Page: 83 / 104

78 Section 8: Maintenance
Digital Label and Decal Press 2 UserÕs Manual
8. When all print media is cleared, turn the printer power OFF , then insert the
Print Pressure Bracket back into its original position within the printer. Be sure
the Print Pressure Bracket is seated properly on top of the Chassis Tab on each
side of the printerÕs interior as shown.
9. Once the Print Pressure Bracket is in the proper position, firmly push each
Securing Lever all the way down until each is in its locked position. Some force
is required to latch these Securing Levers.
10. Reconnect the Sensor Connector by sliding it toward the right-hand side of the
printer until it stops.
11. Replace the Print Cartridge and close the Top Cover. Select the Cancel Print
button in the 32-Bit Print Spooler to cancel the print job, and press the printerÕs
Cancel button to clear its memory. Resend the print job. Note that if the 32-Bit
Print SpoolerÕs
Save last job for reprint option was selected, you simply have
to select the spoolerÕs Print button to resend the job.
NOTE: After the Print Pressure Bracket has been placed back into the printer, you may need to
recalibrate the ribbon sensor according to the calibration procedure at the end of Section 9.
Print Pressure
Bracket
Sensor Connector
Chassis Tab
DLDP2.qxd 3/29/99 9:56 AM Page 78