Primera Impressa 2, User Manual

Page: 31 / 104

Refer to the following steps to load print media into the Supply Tray:
1. Before loading any media, depress the spring loaded panel of the Supply Tray
until it is latched in its ÒdownÓ position. This panel will unlatch and return to
its ÒupÓ position when inserted into the printer.
2. Remove a stack of print media from its packaging. Please note that no more
than about 50 sheets of print media should be loaded at a time. Do not attempt
to load more than this amount.
3. Fan the stack of print media to assure that none of the sheets are sticking
together. Then, neatly stack the media and check to see that it is free of bent
edges. Handle the print media only along the edges and do not touch the
printable side. Oil or dirt from your hands can impair print quality.
4. Place the print media Ñ PRINT SIDE FACING DOWN Ñ between the Media
Guides of the Supply Tray. When inserted properly, the backing side of the
print media will be facing up. Adjust the Media Guides snugly against the
media stack. Be sure the print media fits loosely
beneath the three Media
Guide Tabs shown below. This will assure consistent feeding and printing.
NOTE: Do not attempt to load print media on which you have already printed or which is not
approved. Printing onto such media may damage the printer.
26 Section 4: Ribbons and Print Media
Digital Label and Decal Press 2 UserÕs Manual
Media Guide Tabs
DLDP2.qxd 3/29/99 9:56 AM Page 26