© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Page 177
7
Remove the mounting bolt and washer that secure the flat belt
terminal to the stairarm, remove the flat belt terminal and anti
rotation disc.
Figure 97: Flat Belt Terminal Removal
Flat Belt Terminal Installation
8
Apply a thin layer of AMSOIL GPOR1 synthetic polymeric grease to the
flat belt terminal shaft.
9
Carefully slide on the anti rotation disc and flat belt terminal. Do
not use excessive force. Fasten the anti rotation disc and
replacement flat belt terminal onto the stairarm using the washer
and mounting bolt removed in step 5, torque to 300 inch pounds (25
ft-lbs) or 25 foot pounds.
10
Fasten the stop bolt and washer to the flat belt clamp, but do not
fully tighten at this time.
11
Thread the adjustment bolt through the washer, flat belt clamp and
into the flat belt terminal.
12
Lift the stairarms and then thread the flat belts over the flat belt
pulleys.
Adjusting the Stairarm Pedal Height
13
Loosen, but do not remove the stairarm adjustment stop bolt.
14
Push one of the stairarm pedal's down to its lowest level. Measure
the distance from the bottom of the stairarm tube to the top of the
center beam frame, the distance between the stairarm tube and the
center beam frame should be 3 7/8 inches.
Summary of Contents for AMT 823
