© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Page 316
Figure 262: Drive Input Assembly Alignment
26
Replace the drive input belt over the drive input pulley and the
step up pulley.
27
Place the crank arm on the shaft and secure the crank arm with
mounting bolt and washer. To tighten the crank arm mounting bolt,
insert a socket extension about twelve inches long or equivalent in
the drive input housing cavity, just below the crank arm to prevent
rotation Remove the crank arm bolt, washer and crank arm. Torque the
mounting bolt to 300 inch pounds (25 ft-lbs) or 25 foot pounds.
Note The position of the flat belt pulley on the crank arm and the flat belt pulley
on the input pulley . When the crank arm is replaced, the flat belt pulleys must
be positioned so that they are 180 degrees opposing.
Summary of Contents for AMT 823
