Pratt & Whitney Rzeszów S.A.
MAINTENANCE MANUAL
PZL-10W ENGINE
1992.08.28
72-02-00
Page 315
Export Control Classification: PL/UE 9E999
(5)
Screw the connector in front of engine using two bolts M10; install rear protective cover on output shaft and fasten it by four
bolts M8.
(6)
Lift the engine-by means of lifting sling (see Table 201, item 1) and hoist of lifting capacity no less than 9,8 kN (1000 kG; 28.4
Oz) - above the container base and when the engine is lowered into the container base fasten it, paying attention not to
damage the engine, and the foil protective envelope.
(7)
Slide over the foil envelope on engine rear mounting journal and tighten (screw) by special lock-nut.
(8)
Assembly rear mounting, install mounting ring and screw (tighten) by bolts M8 placing lock-nuts.
(9)
Release the lifting sling from the engine.
(10)
Using adjusting screw being on the mounting rods, made a final positioning and restraint of the engine in relation to the
container base. Secure adjusting screw by lock-nuts.
(11)
Dispose the silica-gel desiccant bags in the following places on the engine:
(a)
in exhaust nozzle (having removed
3 pcs.
the protective cover)
(b)
in engine inlet (having removed
3 pcs.
the protective cover)
(c)
on combustion chamber
2 pcs.
(d)
near fuel metering pump
2 pcs.
(e)
in any other places
2 pcs.
Under each bag with silica-gel desiccant put paraffin paper of suitable size in order to avoid oiling the silica-gel.
(12)
Wrap the engine in two layers of paraffin paper and tie it up using the cord.
(13)
Dispose additionally 8 (eight) silica-gel desiccant bags in different places on wrapped engine, fastening them to the cord
binding the engine.
(14)
In front of and rear of the engine, opposite inspection opening windows on the shipping container top cover, fasten one/by
one silica-gel indicator receptacle.
(15)
Pull the foil protective envelope on the engine, paying attention not to tear it.
