5/16" X 4-1/2" HEX BOLT
5/16" X 4-1/2" HEX BOLT
5/16" WASHER
T-NUT
T-NUT
T-NUT
T-NUT
5/16" WASHER
2 X 6 X 70" SANDBOX BOARD
4 X 4 X 70" REAR TOP
PANEL BOARD
(OFFSET UP)
STEP 48: REAR TOP PANEL BOARD AND SANDBOX BOARD
1: FIND ONE 4 X 4 X 96" UPPER LEVEL CORNER POST AND PLACE IT BESIDE THE PREVIOUSLY
INSTALLED LAG POST.
2: USE A HAMMER TO SEAT THE T-NUTS AFTER INSERTING THEM INTO THE HOLES SHOWN IN
THE DIAGRAM BELOW.
3: CONNECT THE TWO UPPER LEVEL CORNER POSTS WITH ONE 2 X 4 X 70" REAR TOP
PANEL BOARD (OFFSET UP) AND FASTEN WITH 5/16" X 4-1/2" HEX BOLTS AND 5/16"
WASHERS.
4: ATTACH THE 2 X 6 X 70" SANDBOX BOARD (OFFSET HOLES DOWN) TO THE UPPER LEVEL
CORNER POSTS BOTTOM HOLES USING 5/16" X 4-1/2" HEX BOLTS AND 5/16" WASHERS.
86
Summary of Contents for Redbrook Deluxe 381
