Playnation Redbrook Deluxe 381, Manual

Page: 74 / 142

BOLT CAP
3/8" X 6-1/2"
CARRIAGE BOLT
TORQUE WASHER
3/8" WASHER
OF
PLA
Y SE
T
HOLE WILL NOT BE
RIG
HT S
IDE
USED.
3/8" LOCK NUT
THIS HOLE IS TO BE
USED ONLY IF YOUR
YARD RUNS UP-HILL.
IF INSTALLING YOUR
PLAY SET ON
RELATIVELY LEVEL
GROUND THEN THIS
COUNTER-SUNK
HOLES FACE OUT
4 X 4 X 47-3/8"
SWING BEAM MOUNT
STEP 26: SWING BEAM MOUNT
1: THE 4 X 4 X 47-3/8" SWING BEAM MOUNT HAS COUNTER-SUNK HOLES IN THE CENTER AND ON
THE ENDS. INSTALL THE SWING BEAM SUPPORT SO THAT THE COUNTER-SUNK HOLES ON EACH
END OF THE BEAM FACE OUT, AND THE COUNTER-SUNK HOLES IN THE CENTER FACE DOWN.
2: FASTEN THE SWING BEAM MOUNT TO THE RIGHT CORNER POST USING 3/8" X 6-1/2" CARRIAGE
BOLTS AND TORQUE WASHERS. PLACE THE CARRIAGE BOLT INTO THE TORQUE WASHER, THEN
INTO THE HOLE OF THE CORNER POST AND SET WITH A HAMMER. USE 3/8" LOCK NUTS AND 3/8"
WASHERS TO SECURE THE SWING BEAM MOUNT FROM THE OUTSIDE. PLACE BOLT CAPS OVER
THE EXPOSED THREADS AFTER SECURING.
NOTE: THERE ARE TWO MOUNTING POSITIONS FOR THE SWING BEAM MOUNT. USE THE LOWER
HOLES IN THE RIGHT CORNER POSTS IF YOUR YARD IS RELATIVELY FLAT. IF YOUR YARD RUNS
UPHILL THEN YOU SHOULD USE THE UPPER HOLES IN THE RIGHT CORNER POSTS.
64