Planmeca Compact I, Technical Manual

Page: 126 / 244

Chapter F - ADJUSTMENTS
F-16 Planmeca Compact i
MECHANICAL ADJUSTMENTS
Technical Manual
1.12 Removing play of the lifting adapter
CAUTION When removing the play of the lifting adapter, tightening the screws that adjust the
sliding support and the colliding support is recommended to be done by hand. Over-
tightening the screws will increase friction and cause wearing to the sliding support
and the colliding support.
Removing vertical play
a) Loosen the M8 DIN 934 nut that is securing the colliding support in position.
b) Remove the vertical play by tightening the M8x25 DIN 913 screw with a 4mm allen key (figure
on next page, 1).
c) Tighten the M8 DIN 934 nut to secure the colliding support into position while holding the
screw with the allen key.
d) Repeat the above for the other colliding support.
Removing sideways play
a) Unscrew the M8x12 ULS screw holding the sliding support in position and remove the two
ø8.4 DIN 9021washers.
b) Remove the sideways play with the two M6x16 DIN 916 screws (2).
c) Screw the M8x12 ULS screw and the washers back into position. Use some locking agent to
secure the screw into position.
d) Repeat the above for the other sliding support.
M8 DIN 934 nut
1
1
M8x12 ULS screw
2
2