ENGLISH
INSTALLATION STEPS
•
Insert one screw (A) from inside the lid, through the hole
provided in the lid.
•
Place one bezel (6) over the screw, then lin-up the handle (5)
with the threaded end of the screw.
•
Hand start the screw into the handle
•
Repeat procedure for other end of handle
•
Using your wrench securely tighten ALL screws (A)
ASSEMBLING THE DOME
THERMOMETER
Parts Needed:
7 - Dome Thermometer
INSTALLATION STEPS
•
The thermometer comes complete with its own threaded nut
already installed on the thermometer.
•
Simply spin off the threaded nut, and insert the thermometer
through the hole provided in the top of the hood. Firmly hand
tighten the nut back onto the thermometer.
Note:
Take care not to turn the face of the thermometer. This will
result in incorrect readings.
ATTACHING THE SMOKE STACK
Parts Needed:
17 - Smoke Stack
- Smoke Stack Gasket
Hardware Required:
Screw 1/4" - 20* 3/5" x2 (AA)
INSTALLATION STEPS
•
Using the 2 screws (AA) insert those through the stack section,
through the gasket, then finally through the barrel end.
•
Hand start, then secure in place using your Phillips Screwdriver
Note:
DO NOT lower the chimney cap tight to the chimney stack. You
must allow air to escape.
9
