Pioneer DVR-7000, Operating Instructions Manual

Page: 59 / 104

59
En
6 Timer Recording
6 After making the settings, press ENTER.
The program details are shown at the bottom of the
screen for a few seconds then the screen is
automatically exited.
If you haven’t set up the guide channels (or at least
the guide channel for the G-Code programming
number that you entered), the recorder will prompt
you to enter the channel number that the TV program
is showing on.
7 Make sure that you switch the recorder into
standby before the timer recording is due to
start.
Timer recording will not work if the recorder is left on!
• The recorder will automatically switch on two
minutes before the timer recording is due to start.
• If you need to check or change anything in the
program, press SETUP , then ENTER to display the
timer recording program screen. From here you can
check, change or clear any settings you want.
• To calculate whether the recordings programmed
will fit on the disc loaded, move the cursor up to
Confirm and press ENTER . (Keep moving the
cursor up past 1
3
to reach Confirm .)
G-Code programming with the power
off
You can enter a G-Code programming number
when the recorder is in standby.
• You can’t use this feature until you have set up the
guide channels. See page 26 .
• You can’t change the recording mode.
• You can’t program daily or weekly timer recordings.
1 Press G-CODE.
The front panel display shows the current recording
mode and prompts you to enter the G-Code
programming number.
2Use the number buttons to enter the G-Code
programming number.
• To clear the last digit entered, press CLEAR .
3 Press ENTER.
The display shows the timer settings: Date
=
Start
time
=
End time
=
Recording mode/channel.
• If CODE ERROR appears in the display, check the
G-Code number and start again from step 1.
• If CANNOT RECORD appears in the display, it
means that although you entered a valid G-Code
number, the program cannot be recorded for some
other reason (if there is a timer recording already
set for that time, for example).