Phytec phyCORE-i.MX35, Hardware Manual

Page: 66 / 115

phyCORE-i.MX35
58 
PHYTEC Messtechnik GmbH 2010 L-734e_1
J11
Jumper J11 selects whether the signal X_SD2_DATA2 is used as data2 signal of SD2
interface on the i.MX Carrier Board or if the multiplexed CAN1_RX signal is used for
the additional CAN interface on the i.MX35 mapper board. If the jumper is set to 1+2
the SD2 signal is connected to the baseboard. If the jumper is set to 2+3 the CAN
signal is used with the CAN interface on the mapper.
J12
Jumper J12 selects whether the signal X_SD2_DATA1 is used as data1 signal of SD2
interface on the i.MX Carrier Board or if the multiplexed GPIO is used for the
additional CAN interface on the i.MX35 mapper board to enable or disable the CAN
function. If the jumper is set to 1+2 the SD2 signal is connected to the baseboard. If
the jumper is set to 2+3 the GPIO signal is used with the CAN interface on the
mapper.
Table 15: Jumper Settings of PMA-005
J
UMPER
S
ETTING
D
ESCRIPTION
J1 open
closed
Battery charger path on PCM-970 not active
Battery charger path on PCM-970 active
J2 1+2
2+3
FETs Q13, Q14 on PCM-970 disabled
FETs Q13, Q14 on PCM-970 enabled
J3 1+2
2+3
FETs Q15, Q16 on PCM-970 disabled
FETs Q15, Q16 on PCM-970 enabled
J4 1+2
2+3
x_BKUP_SUPPLY supplied by X_VBAT
x_BKUP_SUPPLY supplied by X_LICELL
J5 1+2
2+3
X_OWIRE connected to X_1WIRE
X_OWIRE connected to X_PMIC_RDY
J6 1+2
2+3
USB Host on Mapper is not used
USB Host on Mapper is used
J7 1+2
2+3
USB Host on Mapper is not used
USB Host on Mapper is used
J8 1+2
2+3
USB Host on Mapper is not used
USB Host on Mapper is used
J9 1+2
2+3
USB Host on Mapper is not used
USB Host on Mapper is used
J10 1+2
2+3
CAN on Mapper is not used
CAN on Mapper is used
J11 1+2
2+3
CAN on Mapper is not used
CAN on Mapper is used
J12 1+2
2+3
X_SD2_DATA1 is mapped to PCM-970
X_SD2_DATA1 is used as GPIO for CAN enable