Pfaff 3586-2/02, Instruction Manual, Page: 57 / 156

Input
11 - 17
11
.06
Input of seam programs
Seam programs can be created or modified with the graphics control panel, using the
Create/Modify program function. After the function has been selected, the seam type and
corresponding program number can be selected.
The selection of the seam type depends on the additional seam requirements:
DART 1 DART 2 PLEAT 1 PLEAT 2
Starttack pre - set pre - set pre - set pre - set
Stitch condensing optional optional optional optional
seam start
End tack not possible not possible pre - set not possible
Stitch condensing automatic automatic optional automatic
seam end
Angle seam end automatic automatic not possible not possible
Basting stitch not possible not possible optional optional
Basic status of the seam program input
1 2 3 4 5 6 7 9 0
Enter
8
Esc
Clear
bdf
1 - DART 1
2 - DART 2
3 - PLEAT 1
4 - PLEAT 2
5 - BASTING STITCH
●
After the required seam type has been selected (number keys 1 to 5), the program
number must be entered.
Use the arrow keys to enter the program number or stitch length in the basic
pattern of each seam type.