SINGLE MITRE SAW 50
ENG Rev 1
page 54
A3. Remove flange 2, replace the blade 1 and re-assemble all parts.
Figure 43
– Details of blade and flange
Be sure that the blade is correctly mounteb before going on working
If, after the first use after blade replacing, the machine vibrates too much,
check the correct asembly of the blade
If, after the first use after blade replacing, the machine vibrates too much, CHECK THE
CORRECT ASEMBLY OF THE BLADE
B1. Disconnect again the machine from electric power supply
B2. Move up the safety cover.
B3. Check that the blade is of good quality.
B4. Check that the blade is correctly mounted.
ATTENTION!!!!!!
ALWAYS re-assemble the safety protection covers and tighten their screws
bfore turning on again the machine
Contact PERTICI INDUSTRIES S.r.l. if necessary
Summary of Contents for Univer 50
