SINGLE MITRE SAW 50
ENG Rev 1
page 17
2.5.1.S
ETTING THE BLADE FEEDING SPEED
The feeding speed of the cutting unit can be regulated depending the material to be cut. To
regulate the feeding speed (from 0 up to 0.40 m/sec) use the knob placed on the right side of
the machine (RV in Figure 7). The operator can vary the speed rotating the knob clockwise
(speed down) or counterclockwise (speed up), acting directly to the flow distributor coupled with
the feeding actuator.
Figure 11
– Feeding speed regulator
2.5.2.S
ETTING THE BELT TENSION
The tension of the transmission belt between the electric motor and the blade is correctly
regulated by the manufacture. Anyway, sometimes, it could be necessary to perform again this
operation. To set correctly the tension of the belt:
-
loosen the 4 screws using the forck key and remove the front cover of the steel frame
Figure 12
– Front steel frame cover removal
Summary of Contents for Univer 50
