SINGLE MITRE SAW 50
ENG Rev 1
page 27
3.
SAFETY
3.1.I
NTRODUCTION
The risk analysis and all the relative considerations in this chapter are based on:
-
knowledge of normal conditions and intended use of the machine, as described in this
manual;
-
supposition that the machine is to be used to make single or multiple longitudinal cuts on
wooden boards or composite panels;
-
supposition that all the workers have been correctly trained about residual risks of the
working environment, as requested by current laws and regulations;
-
supposition that any other persons except workers, and especially non adult persons, are not
allowed to go inside the working environment .
3.2.
G
ENERAL
P
RECAUTIONS
-
The operator must be of age, have through suitable training for using the machine, have a
good working experience. Besides the operator has to read very carefully all the information
written in this handbook, and expecially the precautions concerning safety described in this
chapter.
-
Safe use of the machine is guaranteed only for functions and materials described in this
handbook.
PERTICI INDUSTRIES S.r.l. declines any responsibility if the machine is used
for not indicated scopes and not in conformity to these instructions for use
PERTICI INDUSTRIES S.r.l. declines any responsibility concerning safety,
reliability and performance of the machine in case that the operator does not
follow any warnings and suggestions described in this handbook. This is
particularly true for activities concerning monting, use, ordinary and
extraordinary maintenance, repair works.
A machine of this kind could be dangerous if used in a wrong manner
We strongly reccomend that the operator follows
scrupulously all the
instructions and warnings concerning safety
All safety indications as described in this handbook refer exclusively to correct
uses of the machine authorised by PERTICI INDUSTRIES S.r.l. concerning set-
up, working and maintenance operations.
It is strictly forbidden to use the machine for purposes other than those
permitted by
PERTICI INDUSTRIES S.r.l.
It is strictly forbidden to modify the machine and/or some of its parts without
the written consent of
PERTICI INDUSTRIES S.r.l.
Do NOT remove or modify safety protection devices
Do NOT tamper with safety protection devices
Summary of Contents for Univer 50
