SINGLE MITRE SAW 50
ENG Rev 1
page 10
2.2.W
ORK PLACE
In normal working conditions the operator must stand always outside of the machine (see
Error! Reference source not found. and below), in such a position where he/she can see the
entire machine and the working table. The “DANGEROUS AREA” of the machine comprises the
areas where the mobile units operate and also the area close to them.
The necessary working space for a correct use of the machine is 1500mm at minimum all
around the machine. In the following Figure 4 you can see the main safety areas around the
machine, where the operator must pay particular attention to persons and things which can
represent obstacles or a dangers for normal workig operations.
MACHINE ENCUMBRANCE
SAFETY SPACE
A (mm)
B (mm)
C (mm)
S (mm)
1150
900
1500
1500
Figure 4 - Dangerous area and safety space
If the machine is used for continuous cutting or has a rolling support for workpiece, it is
necessary to leave a minimum free room of 1500mm on each side above the maximum
encumbrances of the machine.
The personnel must stay well away from the DANGEROUS AREA when the
machine is working
Install suitable delimitation devices in the frontal part, side parts and rear part of
the machine to avoid that the personnel get in touch with the movable parts of
the machine when the machine is working.
Summary of Contents for Univer 50
