SINGLE MITRE SAW 50
ENG Rev 1
page 20
2.6.1.S
ETTING THE HORIZONTAL CLAMPING UNIT
Open the upper safety guard and put the profile to be cut on the working table, close to the
reference stop.
ATTENTION: the stroke of the clamping cylinder is 50 mm
-
Loosen the handle M and set-up the position of the horizontal cylinders, remebering that their
stroke is 50mm long and that each cylinder can be rotated to adhere better to the profile's
shape.
-
Lock the handle M when you reached the correct desired position.
Figure 16
– Setting of horizontal clamping unit
!!!ATTENTION!!!
Take always care to hands during all the profile clamping phases
!!!ATTENTION!!!
Check that all clamping units, both horizontal and vertical, are not over (or too
close to) the cutting line where the blade operates.
Always check that all working pieces are strongly and firmly locked in position,
before start machining.
Check always the correct settings of the clamping units by blocking, unblocking
and manually forcing he profile before cutting it.
Please check that all the clamping units are strongly and firmly locked in
position, before using them.
!!!ATTENZION!!!
To get maximum locking strength must press P1 & P2 buttons
Contact PERTICI INDUSTRIES S.r.l. if necessary
Summary of Contents for Univer 50
