Pertici Univer 50, Instruction Handbook Manual, Page: 46 / 69

SINGLE MITRE SAW 50
ENG Rev 1
page 44
5.2.W
ARNINGS TO GUARANTEE SAFETY DURING USE
!!!ATTENTION!!!
During any operation be sure that no person other than the operator is inside
the dangerous area of the machine
Do not remove for any reasons the safety guards and protection safety covers
Do not remove or tamper with the safety guards
Do not tamper with the safety protection devices
Check periodically the integrity of the safety guards of the cutting area and
plastic barriers. If damaged or worn, It is necessary to replace them suddenly.
Check periodically the integrity of the safety switch . If damaged or worn, It is
necessary to replace them suddenly.
!!!ATTENTION!!!
Always pay maximum attention to hands during all clamping operations
!!! ATTENTION!!!
During the working cycle pay maximum attention to the area where materials
are moved and to any other operation.
The operator must be sure that no person is inside the dangerous area of the
machine
-
Never remove or open front and rear protection steel made panels (see Figure 1) during
working cycles. It is allowed to remove these panels only for inspection and for
maintenance, as reccomended in this handbook
!!! ATTENTION!!!
It is absolutely FORBIDDEN to use the machine with protection steel made
panels removed or not correctly assembled and fixed
- The upper guard on the machine acts as protection against any materials and residues that
may be produced and thrown up during the machining. However, it is recommended that the
operator wears personal protection equipment against flying splinters and fragments, such as
safety glasses and gloves
The operator must take great care when the cutting unit is moving, and think of
all the possible consequences before approaching the hazardous parts of the
machine with the hands (electrical panel - cutting unit - clamping cylinders)
Always keep the machine disconnected from the electrical power supply when
it is not used