PerkinElmer Photovac MicroFID, User Manual

Page: 50 / 170

MicroFID Software Manual
1. Press CAL and select the desired Cal Memory. Press ENTER
and then press EXIT. You do not want to calibrate MicroFID
at this point.
2. Press ALARM to display the current alarm level. If this value
is correct, press EXIT to return to the normal display.
3. If a new value is to be set, enter the new value, and press
ENTER. This alarm level is specific to the current Cal
Memory.
When an alarm condition is detected, the instrument status changes
to “A larm” and an audio signal is generated. The “Alarm” status
will not clear until the detected concentration falls below the set
alarm level.
PLAY Key
The PLAY key plays back previously recorded data.
To play back previously recorded data:
1. Press PLAY. Two options are available. Pressing ENTER
begins playback where it was last stopped. Press the SETUP
(*) key to set the playback options.
2. Select the start Event. MicroFID will display a list of available
events. Use the ARROW keys to scroll through the list. When
the start event you want is displayed, press ENTER.
NOTE:
An event name may not be available if it has been deleted.
3. If data has been averaged over an interval, select which value
is to be displayed, either the Minimum, the Average, or the
Maximum, and press ENTER. If you are playing back Method
21 data select Background, Sample or Difference to be
displayed.
4. The data can be played back in either numerical or bar graph
display. Press the DISPLAY key to select the desired option.
48