PerkinElmer Photovac MicroFID, User Manual

Page: 112 / 170

MicroFID Software Manual
battery is charging. When the LED turns green, the battery is fully
charged and ready for use.
NOTE:
Leaving MicroFID for more than 3 months without
turning it on may result in the loss of recorded data and setup
parameters. If MicroFID is not used for long periods of time, turn
the instrument on for a few hours every month to avoid loss of data.
The battery pack is 57% lead. (Pb) by weight. This battery pack
must be disposed of properly. Check with local codes for special
disposal instructions.
Emptying the Hydrogen Cylinder
When you transport MicroFID, you should empty the internal
hydrogen cylinder and then refill it when you arrive at your
destination.
If you are traveling by passenger aircraft, you must empty the
cylinder.
WARNING
Do not vent the hydrogen cylinder in a hazardous location. Move to an
open, well ventilated area away from possible ignition sources before
emptying the cylinder.
Hydrogen gas is a fire and explosion hazard when exposed to heat or
flame. The lower explosive limit is 4%.
To empty the cylinder:
1. Turn MicroFID off and open the hydrogen shut­off
valve.
2. Remove the battery pack as outlined in Chapter 1.
3. Locate the purge outlet. It is located on the underside of
the instrument.
110