PerkinElmer Photovac MicroFID, User Manual

Page: 107 / 170

Accessories
2. Snap the other end to one of the shoulder strap
connectors beside the display. The connection point is
selectable for right or left handed operation.
3. Adjust the shoulder pad and strap length for comfort.
Long Sample Probe
A two meter (6’) extension probe (Part No. MX396018) may be
connected to the MicroFID inlet for remote sampling.
If a sampling location is difficult to reach, use the long sample
probe. Ensure MicroFID is level. If MicroFID is tilted from side to
side, gravity will affect the flame height and cause erroneous
readings.
To use the long sample probe:
1. Connect the long sample probe to MicroFID’s inlet.
2. To extend the probe, loosen the knurled nut at the top
of the wand. Pull the extension out and then tighten the
knurled nut down to lock the extension in place.
3. To lengthen the probe further, loosen the lower knurled
nut. Pull the second extension out and then tighten the
knurled nut down to lock the extension in place.
4. When you are using the probe, allow at least 10 seconds
for the sample to travel through the probe and reach the
detector.
NOTE: When using the long probe, be especially careful not to aspirate
liquids or solids as they will damage MicroFID.
5. To reduce the probe, loosen both knurled nuts and push
the extensions back into the probe. Tighten the knurled
nuts down to lock the extensions in place.
105