PerkinElmer Photovac MicroFID, User Manual

Page: 49 / 170

Tutorial Session
Press MAX then press CLEAR twice to reset the Max register.
“M ax Cleared” will be displayed with the current date and time.
After 15 seconds the display reverts to the default display.
Recording of real time data is not interrupted when the MAX key is
pressed or when the Max register is cleared.
AUDIO Key
If an “ Alarm” status, “LoBatt” status or a flame out fault occurs, an
audio signal will be generated. Under these conditions you will hear
the audio signal even if a headset is not connected.
If you have a “L oBatt” status, the audio signal will not clear until
you connect the battery pack to an AC supply or replace the battery
pack with a fully charged one.
If a flame out fault has occurred, the audio signal will not stop until
the flame has been re­started or you turn MicroFID off.
In the case of an alarm condition, an audio signal will be generated
when an alarm is encountered.
To turn off the audio signal on alarm:
1. Press the AUDIO key.
2. Select “A udio Off” with the ARROW keys and press ENTER.
ALARM Key
Press the ALARM key to display the current alarm level or to enter
a new alarm level. The displayed alarm level is specific to the
current Cal Memory. When the Cal Memory is changed, the alarm
level associated with the newly loaded Cal Memory will be
displayed and used during sampling.
To display the current alarm level or to enter a new alarm level:
47