Paul CLIMOS F 200, Original Operating Instructions

Page: 54 / 68

54
Error sensor 4 Sensor break or short circuit
temperature sensor T4 Check or replace sensor
Supply air temperature too
low
Minimum supply air temperature <
setpoint; Supply air temperature > setpoint
+ 1 K
Intake air temperature too
low
Current intake air temperature <
setpoint; longer than 30 minutes
Intake air temp > setpoint; control
after 1 h
Error fan 1 Hall Supply fan speed does not report
manual adjustment of fan speed
Error fan 2 Hall Exhaust fan speed does not
report manual adjustment of fan speed
BUS version incompatible
Software versions of the
components not compatible Replace software versions
Too many devices connected Too many components connected
to the BUS
Remove surplus components
Fan slave not connected Lack of BUS-communication Fan slave connected
Communication error
fan slave Lack of BUS-communication Check BUS-communication
Communication error
defroster
Lack of BUS-communication Check BUS-communication
Communication error
heater battery
Lack of BUS-communication Check BUS-communication
Communication error
flap of the geothermal heat
exchanger Lack of BUS-communication Check BUS-communication
Communication error
general Lack of BUS-communication Disconnection from power supply,
then restart
Heating does not switch off Error BUS-thermostat Replace BUS-thermostat
General control unit error
Lack of BUS-communication with
control unit
Check BUS-communication
Tab. 39: Overview visualisation of errors and error treatment with TFT touch panel