Paul CLIMOS F 200, Original Operating Instructions

Page: 14 / 68

14
Button
Automatic mode
Automatic timing mode
Automatic sensor mode
The automatic mode has 2 automatic functions – automatic
timing and automatic sensor. The manual settings are
deactivated by touching the button.
By means of the automatic timing mode, different fan speeds
(FS0, FS1, FS2 or FS3) can be defined for every day of the
week with a resolution of 15 minutes. This “fan speed week
profile” can be configured and individually adjusted in the
menu Settings/submenu Automatic timing.
The automatic sensor mode regulates the fans according to a
pre-settable linear characteristic curve depending on an
analogue indoor air quality sensor (also CO
2
, air humidity and
temperature combined).
Button
Menu mode By touching this button, you reach the information, setting and
setup menu.
Button
Standby mode By means of the standby function, the ventilation device is
switched into an energy-saving mode. In standby mode, the
power consumption of the entire device decreases to less than
1 W. The screen display gets dark; however, the touchpad
remains active in order to “wake up” the system. One touch of
the touchpad suffices to terminate the standby mode.
According to DIN 1946-6, during the heating
period, the plant must be in operation for at least
12 h/d and must not be switched off longer than 1 h each
time!
Button
Help By touching this button, you are redirected to a context-
sensitive help menu. If this key is grey, no help text is stored.
Button
Activate key lock By touching this button, the touchpad is deactivated, except
for this button. The screen is dimmed and becomes inactive
(cleaning status).
Button
Deactivate key lock If it is touched again and held down (for approx. 2-3 s) you
reach the start menu again.
Button
Checkmark By touching this button, the desired or available parameter is
selected or confirmed.
Button
Enter By touching this button, it is possible to navigate in the
different submenus. Changed parameters are copied into the
memory.
Button
Cancel / back By touching this button, you change from a menu into the next
higher menu level without copying possibly changed data.
Signalling
messages A flashing yellow warning triangle at the upper right edge
symbolizes a piece of information or an error. These are
registered in the menu Information/Current Message and
errors additionally in the menu Information/Last Message.
Signalling
filter symbol / filter run-
time For cyclic filter checking, an operating hours counter is
integrated in the control. The operating hours are subtracted
from the preset filter run-time by counting backwards and are
displayed in days below the filter symbol. The filter symbol
colour changes from white to yellow when the filter run-time is
10 d and from yellow to red when the filter run-time has