Paul CLIMOS F 200, Original Operating Instructions

Page: 42 / 68

42
Terminal X1 master controller Contact designation
X2.1 Digital input or output 1 (can be parameterized)
X2.2 Digital input or output 1 (GND)
X2.3 Digital input or output 2 (can be parameterized)
X2.4 Digital input or output 2 (GND)
Tab. 27: Terminal assignment DIO1 und DIO2
Operation without a control unit connected 3.4.7
When operating the ventilation device without control panel, the control operates according to the
operating mode set last.
The control panel may only be disconnected from the BUS in de-energised condition.
Disconnection during the operation results in a communication error!
Commissioning of the CLIMOS 3.5
Operational readiness 3.5.1
Operational readiness is ensured if the requirements acc. to country-specific regulations
are met. For that purpose, cleanliness of the air duct material, the availability, correct
installation and operational readiness of the entire ventilation equipment provided for the
plant must be particularly ensured.
Check all safety-relevant parts and perform a functional test!
Adjusting the air volume flow 3.5.2
After having verified the operational readiness, the CLIMOS can be commissioned as follows. The
ventilation device is configured according to plant design for the total intake air volume flow with nominal
ventilation. This nominal air volume flow is parameterised in accordance with the characteristic curves of
the chart 1 Fig 43 (with control unit TFT touch panel) in the setup / submenu Fan speeds or according to
Tab. 29 (with control unit LED control panel).
3.5.2.1 Adjustment of the nominal air flow with TFT touch panel
For adjustment of the ventilation unit, the fan speed 2 (FS 2) for nominal air flow is set. The following
settings have to be made using the TFT touch panel:
Symbol Designation Explanation / actions
Button
Menu mode Connect the first TFT touch panel
Buttons
Navigation By touching the button Menu mode, you reach the main menus.
Button
Password By touching the navigation buttons, select the main menu setup
and confirm with Enter.