Paul CLIMOS F 200, Original Operating Instructions

Page: 32 / 68

32
Fig 22: Mounting position inclined wall vertically
Air duct connection 3.3.8
When mounting the air ducts, the following points must be taken into account:
•
Mount the types of air ducts of the ventilation plant to the connection stubs according to the present
construction form right (type A) or left (type B), see label air ducts next to the type plate.
Fig 23: Arrangement of air ducts depending on construction type – right (type A) or left (type B)
•
Use air duct material with air resistance as low as possible, and connect the ventilation
components air-tight among each other;
•
The connection stubs of the device are made of EPP and have sleeve dimensions DN 125;
•
The intake air and exhaust air ducts must be insulated in such a way that they are vapour-diffusion
tight;
•
In the event that a low point is unavoidable when installing the exhaust air duct from the device’s
exhaust air stub to the exhaust air outlet, a connection for condensate drain must be provided at
that point;
Fig 24: Arrangement drainage of the intake air duct and exhaust air duct
•
If a silencer is provided at the exhaust air stub, it must be guided upwards by means of a bend in
order to protect it against drenching caused by condensate returning from the exhaust air duct.
•
If the exhaust air is guided over the roof, this guidance must be equipped with a double-wall or
insulated roof lead-through. Thus, condensate formation between the roof boards is prevented.
•
For the supply and extract air ducts, we recommend a thermal and vapour resistant insulation in
order to avoid unnecessary temperature loss both in summer and winter.
B
A