Paul Agnew Aerion Series, Installation, Operating And Maintenance Manual

Page: 95 / 104

ERROR CODES
90.
Aerion Range
ERROR CODE ACTION DESCRIPTION POSSIBLE CAUSE
F03 Contact service 5 second beep from the receiver.
Ignition process is interrupted. No
response from receiver and no
ignition.
Thermocouple wiring not in
order / interrupted
F04 Ignition failure.
Wait one minute
then try again.
5 second beep
from the receiver.
No pilot flame within 30 seconds.
After third attempt F06
No response from the receiver.
• No gas
• Air in the line
• No spark
8 wire connector loose or
disconnected.
F06 Contact service Third time start attempt within 5
minutes
• No gas
• Air in the line
• No spark
F12 Contact service Motor turns to pilot light position Receiver temperature
above 60°
F13 Contact service Motor turns to pilot light position Receiver temperature
above 60°
F14 Contact service 5 second beep. No reaction from
the heater and no ignition
Wiring not in order
F19 Contact service Pilot flame goes out when the
main burner is energised
Thermocouple defective
F26 Contact service No high flame regulation possible Receiver temperature
above 60°
F31 Contact service No reaction from the heater. No
control via the handset remote
Receiver defective
F40 Battery symbol Battery voltage in the handset
remote low
Replace batteries 2 x 1.5V
AAA
F46 Contact service No reaction from the heater Bad connection between
the receiver and handset
remote