Paul Agnew Aerion Series, Installation, Operating And Maintenance Manual

Page: 94 / 104

REMOTE CONTROL INSTALLATION
89.
Aerion Range
BATTERIES
Remote Handset: 2 x 1.5V "AAA", Quality alkaline recommended
RECEIVER
4 x 1.5V "AA", Quality alkaline recommended for maximum life.
An alternative AC Mains Adaptor may be used to power the Receiver instead of the 4 x “AA” batteries. Only an AC
Mains Adapter supplied by the distributer or it’s agent may be used. The Mains Adaptor is plugged into the DC 6V
socket on the end of the receiver.
Note - if the AC Mains Adapter is used, remove the 4 x AA's from the Receiver, failure to do so could result in
damage and failure of the Receiver. During a period of power outage, the receiver may be unplugged and batteries
returned to the Receiver.
REPLACING THE BATTERIES
HANDSET:
There is a battery level indicator on the display of the handset. When this gets low remove the cover on the rear of
the handset and replace the battery with 2 x 1.5V "AAA", Quality alkaline recommended for maximum life.
RECEIVER:
Three short audible beeps will sound when the appliance is on to indicate that the batteries in the receiver are
getting low.
When the batteries get very low the appliance will be turned off by the remote control. This will fail to happen if the
power supply is interrupted.
To replace the Receiver batteries, slide the cover off of the top of the receiver and use the ribbon to pull the
batteries out. Replace the batteries with new 1.5V AA's, ensuring that the ribbon is located under the batteries and
that the polarity is correct on all 4 batteries.
Never mix new batteries with old; this will result in the new batteries being emptied very quickly.
When the batteries are replaced, it may be necessary to reset the transmitter code, as detailed in the next section.
SETTING THE TRANSMITTER CODE
Press and hold the RESET button with a sharp object (pen or screwdriver) until you hear two audible beeps. After
the second, longer beep, release the RESET button.
Within the next twenty seconds press the down button on the remote handset until you hear an additional long
signal confirming the code is set.
The Receiver is located in the Control Hatch panel.