Paul Agnew Aerion Series, Installation, Operating And Maintenance Manual

Page: 57 / 104

52.
INSTALLATION INSTRUCTIONS
Removal of control hatch from the transit bracket
Step 1: Remove the protective material from around the
control hatch.
Step 2: There are four screws (each side) securing the
control hatch to the transit bracket. With a Phillips head
screwdriver remove the 4 screws LH/RH side securing the
control hatch to the transit bracket. Before removing the last
screw, support the bottom of the control hatch, remove the
last screw and lay the control hatch on the protective material
to protect against damage to the power coating.
Step 3: Locate the transit bracket under the base of the
heater. There are two bolts one each side securing the
transit bracket to the chassis. With a 10 mm spanner or 10
mm nutsert remove the bolts from the bracket and discard.
The transit bracket after removing the securing bolts can be
pushed and accommodated under the base of the heater.
Fitment of the control hatch
The control hatch is in two parts, control hatch surround and control hatch door.
The control hatch enclosure is inclusive of the bracket which secures the gas control and module.
Control hatch enclosure
Provide a cut-out for the control hatch surround in the RH/LH
side enclosure with dimensions of 175 mm wide x 282 mm
high and 150 mm from the base (floor) or, the front enclosure
RH/LH side then the control hatch is installed 50 mm from the
base (floor).
Feed the top flange of the control hatch surround through the
cut-out and when positioned vertically, secure the top flange
to the RH enclosure with the two screws provided.
Fit the control hatch door and secure with the four thumb
screws (tighten via 5mm Allan key) provided.
Aerion Range