Paul Agnew Aerion Series, Installation, Operating And Maintenance Manual

Page: 48 / 104

800T CLEARANCES
43. Aerion Range
METAL FRAME
CLEARANCE TO COMBUSTIBLES
Extra notes:
•
For timber frame installations the unit can be either floor mounted or mid mounted. However, for steel frame installations, the appliance must
be mid mounted.
• Drawings above are for visual illustration purposes only. When the appliance is symmetrical you may choose to change
the location of the control box or vents given you meet the minimum clearance requirements.
• For installations where the control box is below the appliance – to the side of the cavity, you may choose to install the vent below the control
box (not shown in the drawings) given the appliance is raised high enough to allow the minimum clearances and there is adequate space for
the vent.
• The external façade/surrounding of the timber/steel frame should be constructed with 9mm Villa board (minimum).
* G dimension is only applicable if the control box is installed to the side of the cavity, inline or above from the bottom of the appliance. Similarly, H
dimension is only applicable if the control box is installed either directly below the appliance or below the appliance – to the side of the cavity
Possible vent locations
4 minimum vents required for airflow
H*= 395mm
Possible control box locations
Unit Dimensions
Metal Stud Frame
FOR METAL STUD FRAME, UNIT MUST BE IN PLACE
In mm Clearance to the inside of the metal stud
Unit Height
+50mm top
Unit Width +150mm
either side to internal
side of metal stud
Depth Clearance
Metal Studs fixed to rear combustible wall.
25mm Steel Battens fixed to combustible wall +13mm Firestop Board
+50mm air gap to unit
H W D A B C
990 1005 385 1040 1305 473